Question

Do stepper motors need for segmented spiral baffle production?

Answer 1

Segmented spiral baffles require stepper motors, which are the most affordable choice for motion control solutions and are more cost-effective than servo motors.

What are the roles of stepper motors in spiral baffles?

Stepper motor is a displacement motor, so it is mainly used in some occasions with positioning requirements, such as: wire cutting table dragging, hair planting machine table (pore positioning), packaging machine (fixed length), basically involving positioning occasions are used.

The amount of angular displacement can be controlled by controlling the number of pulses, so as to achieve the purpose of accurate positioning; At the same time, the speed and acceleration of motor rotation can be controlled by controlling the pulse frequency, so as to achieve the purpose of speed regulation. Although stepper motors have been widely used.

With each electrical pulse, the stepper motor rotates an angle, driving the machine to move a short distance. 

Stepper motors can easily achieve correct positioning operation, and the correct rotation angle and speed can be controlled by pulse signals.

Answer 2

How to install the segmented spiral baffle? Below I will introduce you to the installation method of segmented spiral baffle:
1. Before installation, the machine parts must be cleaned, and the lubrication pipelines should be unblocked and clean.
2. Check whether the parts are complete, whether there is damage, and the preparation of installation tools, and then the installation work can be carried out.
3. According to the equipment installation drawing and basic design drawing, check the location, size and connection and tightening of the oblique support and anchor bolts or embedded steel plates.
4. Single and double helix classifiers with a diameter of 1500mm or less, the sink has been welded into one by the final assembly of the manufacturing plant, which can be directly installed on the foundation, and can be welded after verifying its inclination angle and size.
5. Single and double helix classifiers with a diameter of more than 2000mm, the sink is welded at the installation site.
6. Weld the transmission frame and sink stringer according to the corrected position of the drawings and bolt them.
7. The single and double spiral classifiers with a diameter of more than 2000mm should be installed with a large oil groove, and the small oil groove should be fixed after finding the correct position.
8. Install the spiral and lower support in the base and sink.
9. Install the manual centralized lubrication device.
10. Connect and install the lower support with the lifting device.
11. The allowable deviation and inspection method of each part of the screw classifier installation should comply with the regulations.